TERMINATION STYLE M1 AND F1
- Prepare Cable as shown
- Solder the Core of the Cable to the Inner Contact (1) of the Connector
- Solder the Screen of the Cable to the Connector Body
|
 |
TERMINATION STYLE M2 AND F2
- Prepare Cable as shown
- Fit Heat Shrink Sleeve (4) and Cap (3) over Cable
- Fit Core of Cable into Inner Contact (1) and Cable Screen over Outer Connector Body
- Solder the Cable Core to Contact
- Push Cap (3) over Cable Screen
- Solder Cap (3) and Cable Screen
- Shrink Sleeve (4) over Cap (3) and Cable
|
 |
TERMINATION STYLE M4, M42 AND F4, F42
- Prepare Cable as shown
- Fit Heat Shrink Sleeve (3) over Cable
- Push Cable fully into Connector Solder Cable Core to Inner Contact (1), and Cable Screen to Connector Body (2)
- Push Insulator Pad (4) into Back of Connector Body, and assemble Retaining Screw and Cable
- Shrink Sleeve (3) over Connector and Cable
|
 |
TERMINATION STYLE M6 AND F6
- Prepare Cable as shown
- Fit Heat Shrink Sleeve (4) and Sleeve (3) over Cable
- Push Cable into Body (2)
- Solder Cable Core to Inner Contact (1)
- Push Sleeve (3) over Cable until it is against Shoulder of Body (2) and Solder
- Shrink Sleeve (4) over Connector and Cable
|
 |
TERMINATION STYLE M46 AND F46
- Prepare Cable as shown
- Fit Heat Shrink Sleeve (3) over Cable
- Push Cable fully into Connector Solder Cable Core to Inner Contact (1) and Cable Outer to Connector Body (2)
- Push Insulator Pad (4) into Back of Connector Body and assemble Retaining Screw (5)
- Shrink Sleeve (3) over Connector and Cable
|
 |